Operating instructions

Start Up
Copyright © 2013 EVG 9
1
1
1.3.1 Disconnected State
 Module is physically disconnected (optional).
 Module is ignored and not controlled by the equipment.
 Is entered and left when instructed by the user.
Figure 6 - Disconnected State
Right-click a module and select Connect to switch from disconnected to
connected state (or Disconnect to switch from connected to
disconnected state).
Figure 7 - Connect Module
1.3.2 Disabled / Not-Initialized State
 Module is out of service but under control by the equipment.
 Module is automatically initialized on equipment initialization.
 Is entered automatically on equipment shutdown, module failure or
when instructed by the user.
Figure 8 - Disabled State
60 of 370