Operating instructions

Monthly Maintenance
Copyright © 2012 EVG 99
5
5
10) Enter the force into field “Setpoint” and press “OK” to confirm.
Figure 106 - Load Cell Test - Enter Piston Force
11) Start measurement. Sum up the three values [kN] on the display of
the measuring tool and compare with the Setpoint.
12) Remove the measuring gauge and the load cell with caution. Don’t
forget to install the glass plate (if equipped) and the screw shown
in Figure 100 – Remove screw.
5.6 Main Pressure Regulator Unit
Check the main pressure regulator (1) and the filter for the presence of
oil or water.
1
306 of 370