EIN Extractors Manual for Installation, Use and Maintenance Passionate about style 1 Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer.care@cda.eu W : www.cda.
Important The manufacturer cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that the manufacturer reserves the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a commercial environment.
Using your Extractor For best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately 15 minutes after the end of cooking. Control Panel A – Light switch B – Power indicator light C – Power switch A A1 Fig. 1 A2 B C C1 C3 C2 C4 To switch the extractor light on or off • Slide the light switch to position A1 for off, or A2 for on.
Care and Maintenance IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY. Cleaning You should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. You can clean your extractor effectively by simply using a dilute solution of water and mild detergent and drying to a shine with a clean cloth, for example the CDA E-Cloth.
Changing the (circular) charcoal filter (re-circulating only): To ensure best performance of your extractor, you should replace the charcoal filters every four to six months, depending on use. Please note the charcoal filter cannot be washed. To attach a new charcoal filter, follow the steps below: 1. Remove the cover panel (acrylic filter model) or grease filter (aluminium filter model) as described above. 2.
Mains Electricity Connection THIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY A COMPETENT PERSON, USING FIXED WIRING VIA A DOUBLE POLE SWITCHED FUSED SPUR OUTLET AND PROTECTED BY A 3A FUSE. We recommend that the appliance is connected by a qualified electrician, who is a member of the N.I.C.E.I.C. and who will comply with the I.E.T. and local regulations. The wires in the mains lead of this appliance are coloured in accordance with the following code: BLUE = NEUTRAL, BROWN = LIVE.
Electrical Information Mains electrical voltage: 230 – 240Vac. Total rated power consumption: 160W. Troubleshooting If your extractor is not working: 1. Check that the mains supply has not been switched off. 2. Check that the fuse in the spur has not blown. Contact CDA Customer Care A : Customer Care Department, The CDA Group Ltd, Harby Road, Langar, Nottinghamshire, NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.
Installation When the extractor is to be installed above an electric hob, the minimum distance between the hob and extractor must exceed 600mm (650mm is recommended). When the extractor is to be installed above a gas hob, the minimum distance between the hob and extractor must exceed 700mm (750mm is recommended).
Installation 1. Mark the positions of the fixing holes on the wall using the dimensions shown above. 2. Drill and plug the wall with appropriate fixings, suitable for the wall type you are fixing the extractor on. 3. Mount the brackets and securely tighten. 4. Hang the hood on the brackets and adjust the brackets and height to suit. The adjustment mechanism is shown below. 5. Once the hood is levelled and square against the wall, adjust the bottom panel as required. 6.
Energy Efficiency Information Attribute Model Identification Annual Energy Consumption Symbol AECHood ein60si 80.8 Value ein60fsi 79.3 Units Time increase factor Fluid Dynamic Efficiency f FDEHood 1.8 6.1 1.8 6.8 Energy Efficiency Index EEIHood 98.8 97.7 Measured airflow at Best Efficiency Point Measured Pressure at Best Efficiency Point Maximum airflow QBEP 115.2 118.4 m /h PBEP 178.0 189.0 Pa QMAX 197.0 202.
To contact our Customer Care Department, or for Service, please contact us on the details below. Passionate about style 12 Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.
