Specifications
4
Care and Maintenance
IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING
OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE
ELECTRICITY SUPPLY.
Cleaning
You should use a nonabrasive cleaner. Any abrasive cleaner (including Cif)
will scratch the surface and could erase the control panel markings.
You can clean your extractor eectively by simply using a dilute solution
of water and mild detergent and drying to a shine with a clean cloth, for
example the CDA E-Cloth.
Cleaning the grease lter
The grease lter should be kept clean to minimise the risk of re.
At least once a month you should remove and clean the grease lter with
hot soapy water. You can also wash the grease lter in a dishwasher, ensuring
that you place it in an upright position to prevent damage from other items
in the dishwasher. After rinsing and drying, replace the lter.
To remove the grease lter, push in the button on the handle and then pull
down on the lter at the front as shown in gure 2. When you have released
it at the front, then you can pull the lter out completely.
Please note:
Cleaning the grease lter in the dishwasher may lead to discoloration. This is
normal and does not constitute a fault with the appliance.
Changing the charcoal lter (re-circulating only)
To ensure best performance of your extractor, you should replace the
charcoal lters every four to six months, depending on use. To attach a new
charcoal lter, rst remove the grease lter as described above. Then oer
up the charcoal lter to the side of the motor as shown in gure 3 and turn it
clockwise until it locks into place.
Fig. 2
Fig. 3