Specifications

43
8
INSTALLATION
IMPORTANT
• The appliance should be installed by a QUALIFIED INSTALLATION TECHNICIAN.
The appliance must be installed in compliance with regulations in force.
The built under double oven shall be fitted under the working surface into a kitchen
base unit (width and depth 60 cm) but you must ensure that it is properly ventilated.
Installation requires a compartment as illustrated in figures 8.1b, 8.2c, 8.3c.
CAUTION: Do not lift the double oven by the door handles.
WARNING !
• We would point out that the adhesive which bonds the plastic laminate to the furniture
must withstand temperatures not less than 150° C to avoid delamination.
• The appliance must be housed in heat resistant units.
• The walls of the units must be capable of resisting temperatures of 75° C above
room temperature.
TO BUILD IN THE DOUBLE OVEN
INSTALLATION "A" BETWEEN EXISTING SIDE CABINETS (560 or 600 mm GAP)
(figs. 8.1a, 8.2a, 8.1b, 8.2c)
• Mount the 2 (two) metal supports “B” (supplied with the appliance in a separate kit)
as indicated in Figs. 8.1b or 8.2c).
• Fig. 8.2c only - prepare 2 wood uprights “A” (width 20-50 mm, thickness 18 mm,
length 650 mm); mount the 2 wood uprights “A” to the cabinet walls as indicated in
figure.
• Build in the double oven making it slide on the metal supports “B”.
INSTALLATION "B" BETWEEN SIDE CABINETS BY REMOVING PROVIOUS HOUSING
(figs. 8.2b, 8.2c)
• Remove previous housing.
• Mount the 2 (two) metal supports “B” (supplied with the appliance in a separate kit)
as indicated in Fig. 8.2c).
• Prepare 2 wood uprights “A” (width 20-50 mm, thickness 18 mm, length 650 mm);
mount the 2 wood uprights “A” to the cabinet walls as indicated in figure.
• Build in the double oven making it slide on the metal supports “B”.