Troubleshooting guide

Care and Maintenance

Removing Shelves

• To remove any of the shelves from the rail

compartment, remove the plastic stops on

either side of the shelf by unscrewing the

Phillips screws that holds each post in place.

Please ensure these are replaced when the

shelf is put back.

Humidity Control

The wine cooler is equipped with a system for

maintaining the correct level of humidity. Fill the

small plastic reservoir (humidity box) ¾ full with

water, and ﬁt onto the runners found on the top

shelf of the wine cooler. Check the water level

regularly and reﬁll as necessary.

Please ensure the reservoir is positioned correctly

on the runners on the top shelf to avoid the

possibility of water spillage.

See figure “AA”

FIG “AA”

Replacing Your Light Bulb

NOTE:

Before removing the light bulb, turn off

the appliance and disconnect from the

power supply. Failure to do so could

result in electrical shock or personal

injury.

• Turn off the light.

• Remove the screw with a Phillips

screwdriver.

• Pull down to remove the lamp cover .

• Unscrew the bulb .

• Replace with a 15-watt bulb that is the same

shape and size.

• Replace the lamp cover and tighten screw .

Lamp Cover Interior Section

Screw Bulb

Top Lamp Holder

Note: The bulb should not exceed 15

watts.