Built-in Wine Cooler BWC600SS CWC600SS
Important Safeguards When using an electrical appliance, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: • This appliance is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible person to ensure that they can use the appliance safely. • Young children should be supervised to ensure that they do not play with the appliance.
Connection to the Mains Supply The BROWN wire is the LIVE wire and must be connected to the terminal which is marked with the Letter ‘L’ or coloured RED. Always ensure that the plug cord grip is fastened correctly. Check that the voltage marked on the product corresponds with your supply voltage. This product is fitted with a 13A plug complying with BS1363.
Features of Your Wine Cooler Shelves Cabinet Door Handle Digital Control Panel Bottom Shelf Adjustable Legs 4
Installation Instructions Before Using Your Wine Cooler Before connecting the Wine Cooler to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system caused by handling during transportation. • Clean the interior surface with lukewarm water using a soft cloth. • The door on this appliance can be opened from either the left or the right side. The unit is delivered with the door opening on the left side.
Installing the Handle Attention • Store wine in sealed bottles. • Do not overload the cabinet. • Do not open the door unless necessary. • Do not cover shelves with aluminum foil or any other shelf material which may prevent air circulation.
Reversing the Door Swing of Your Appliance 1. Open the glass door and remove the two screws under the right bottom corner of the glass door that are used to hold the right lower hinge to the glass door. Be careful to support the glass door with hands to prevent it dropping after removing the screws. (Figure 1) Should you desire to reverse the opening direction, please follow the instructions below . Figure 1 2. Pull down to remove the glass door and place it on a padded surface to prevent scratching it.
Operating Your Wine Cooler Setting the Temperature Control The Wine Cooler should be placed in a position where the ambient temperature is between 0-35°C. If the ambient temperature is above or below this range, the performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate. The range of 5-18°C may not be reached.
Care and Maintenance Replacing Your Light Bulb NOTE: Before removing the light bulb, turn off the appliance and disconnect from the power supply. Failure to do so could result in electrical shock or personal injury. Removing Shelves • To remove any of the shelves from the rail compartment, remove the plastic stops on either side of the shelf by unscrewing the Phillips screws that holds each post in place. Please ensure these are replaced when the shelf is put back. • Turn off the light.
Cleaning Your Wine Cooler Moving Your Wine Cooler • Turn off the power, unplug the appliance, and remove all items including shelves and rack. • Remove all items. • • Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a pint of water. Securely tape down all loose items (shelves) inside your appliance. • Turn the adjustable leg up to the base to avoid damage. • Tape the door shut.
Problems with Your Wine Cooler You can solve many common Wine Cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling customer service. Troubleshooting Guide Problem Possible Cause Wine Cooler does not operate. Not plugged in. The appliance is turned off. The circuit breaker tripped or a blown fuse. Wine Cooler is not cold enough. Check the temperature control setting.
