Technical information

15
Troubleshooting
If the clothes are not dry after normal drying time:
- Check that the filter is clean. A blocked filter will restrict the airflow.
- Check that you used the correct heat setting and did not overload
the dryer.
- Check that the condenser unit and associated duct work are clean. If
blocked, these will restrict the airflow.
- Check that your dryer is heating - the area below the door should
feel warm to the touch after the first 10-15 minutes of its programme.
- Check that the bottle full warning light is o. If it is on then the bottle
may be full or incorrectly fitted.
If your appliance does not work, check the following points before
contacting CDA Customer Care
•Check that there is power to the appliance.
•Check that the machine is switched on and the door properly
closed.
- Check that the Activate button has been pressed and that the
Display is illuminated.
- Check that the water bottle has been withdrawn from, and replaced
into, the machine. The bottle full warning light should be o.
•This appliance has a resettable cut-out. Check this has not
operated. Press the red button on the right hand side at the
back of your dryer. If the cut-out has operated a sharp “click”
will be heard. This cut-out only operates if the airflow is
severely restricted so make sure the filter is clean and that all other
restrictions are removed before restarting.
•Check the fuse in the moulded plug.