Technical information

13
•Firmly pull the condenser using
the handle to remove it from the
dryer.
•Rinse between the plates under
a tap or with running water to
remove any lint or flu.
•Carefully shake any excess water
from the condenser.
•Whilst the condenser is removed,
clean as much flu as possible
from inside the ducting by
reaching a hand into the machine.
In particular, keep the passage
from the fan clear (on the right
hand side of the condenser duct).
•Carefully push the condenser
back into its housing, until it is
pushed fully home and a “click” is heard.
Please note:
All lint and flu must be removed from around the seals before
replacing the condenser into its housing or water may leak.
The dryer may leak if the condenser is not correctly re-installed.
The condenser will discolour through use. This is normal and does
not constitute a fault.
fig. 2