Technical information

16
Troubleshooting
If the clothes are not dry after the normal drying time:
- Check that the filter is clean. A blocked filter will restrict the airflow.
- Check that you used the correct heat setting and did not overload
the dryer.
- Check that the condenser unit and associated duct work are clean.
If blocked, these will restrict the airflow.
- Check that your dryer is heating - the area below the door should
feel warm to the touch after the first 10-15 minutes of its programme.
- Check that the bottle full warning light is o. If it is on then the bottle
may be full or incorrectly fitted.
If your appliance does not work, check the following points before
contacting CDA Customer Care:
• Check that there is power to the appliance.
• Check that the machine is switched on and the door is properly
closed.
• Check that the “Activate” button has been pressed and that the
display is illuminated.
• Check that the water bottle has been withdrawn from, and replaced
into, the machine. The bottle “Full” warning light should be o.
• This appliance has a resettable cut-out. Check this has not been
activated. Press the red button on the right hand side at the back
of your dryer. If the cut-out has been activated a “click” will be
heard. This cut-out only operates if the airflow is severely restricted
so make sure the filter is clean and that all other restrictions are
removed before restarting.
• Check the fuse in the moulded plug.