Technical information

14
• Firmly pull the condenser using the
handle to remove it from the dryer.
• Rinse between the plates under a tap
or with running water to remove any
lint or flu.
• Carefully shake any excess water
from the condenser.
• Whilst the condenser is removed, clean as much flu as possible
from inside the ducting by reaching a hand into the machine. In
particular, keep the passage from the fan clear (on the right hand
side of the condenser duct).
• Carefully push the condenser back into its housing, until it is pushed
fully home and a “click” is heard.
Please note:
All lint and flu must be removed from around the seals before
replacing the condenser into its housing or water may leak.
The dryer may leak if the condenser is not correctly re-installed.
The condenser will discolour through use. This is normal and does
not constitute a fault.
fig. 2