Technical information

APPENDIX A
3/31/2008 Rev. 4.3 A-3
Figure A-5
EMPTYING RESERVOIR
Care for the CI-510CS Temperature Control System as you would any other sensitive instrument. The
water in the hose needs to be completely drained after your experiment is finished. Empty the
reservoir, by leaving the “IN” port on the controller panel open to air. Connect one hose from the
Temperature Control Attachment to the “OUT” port on the controller module. Connect the water
connection tube to the other hose from the Temperature Control Attachment and insert it in a
container (Figure A-6). Turn on the controller module and allow it to empty. It may be necessary to
rotate the unit from side to side to get all excess water out of the reservoir. Store the components so
that the hoses are not crushed or twisted. This permits the water to flow freely throughout the hoses
for future usage.
Figure A-6 Configuration for emptying reservoir.