Specifications

28
Stop notch
Guard rail
Guard rail
Stop noch
Telescopic Sliding Shelf Supports
The telescopic sliding shelf supports make it safer and easier to
insert and remove the oven shelves and trays. They stop when
they are pulled out to the maximum position.
Important! When fitting the sliding shelf supports, make sure
that you fit:
– The slides to the top wire of a rack. They do not fit on the lower
wire.
– The slides so that they run out towards the oven door.
– Both sides of each pair of shelf slides.
– Both sides on the same level.
To fix the sliding shelf support onto the side racks:
– Screw the side rack onto the oven wall (Fig. 11).
– Fit the sliding shelf support onto the top wire of a rack and press
(Fig. 11). You will hear a click as the safety locks clip over the
wire.
Left
Right
Fig. 11
Fitting the Oven Shelves
– Assemble the wire racks to the oven walls using the 2 screws (Fig. 9).
– Slide into the guides, the shelf and the tray (Fig. 10). The rack must be fitted so that the safety notch, which stops
it sliding out, faces the inside of the oven; the guard rail shall be at the back.
– To dismantle, operate in reverse order.
Fig. 10Fig. 9