manual

10
- Connecting gas
- Ensure that it has been adjusted to local fuel types.
- If it has not been adjusted, follow adjustment instructions as set out in
‘Adjustments for alternative gas types’.
-
If it is to be fuelled by liquid gas, only a certified and approved pressure
regulator is to be used.
- Connect the appliance to gas cylinder or other gas supply in accordance
with local codes and regulations.
- Connecting appliance
- The hob can be installed with either an approved stainless steel flexible
pipe or a rigid pipe.
-
Connection is made to the GJ1/2” threaded elbow.
- The gasket has to guarantee the connection holds fast.
- The elbow can be turned by releasing the nut. Once the desired position
has been established it is to be tightened again.
Fig. 3
Important: After the installation check there are no leaks by using a soap
solution and never a flame.
The manufactured declines every responsibility if these safety
standards are not respected.
Fitting for metal pipe
Gasket
Nut
Shaft
pipe