User manual

8
3.4 Keyboard setup
.
Network setup: Set the network parameter of keyboard including IP address, subnet
mask, gateway, start port, WEB port and physical address
User management：It is only open to advanced administrator to amend loading of
PTZ、DVR、DEV and access authority of keyboard user.
Password setup： The current loading user can amend his name and password.
Equipment management： Amend the relevant parameter of control equipment.
Hardware setup：Set the illumination of keyboard LED, touch-tone, Matrix alarm
tone and prompt tone.
Delay setup：Set keyboard delay lockup, Key-press backlight delay close and delay
time for closing LED backlight
Key-press check;
Joystick check;
Hardware Display check including LED, Key-press backlight and control form
light;
monitor Relay check;
Serial port check including RS-485 and RS-422;
Shutter check;
Joystick calibration: Calibrate central value of joystick, control blind area and
maximum value of all directions of joystick.
Time setup: Calibrate time of keyboard.
Language selection: Set the language of keyboard operating screen and WEB setup
screen. Now it supports Chinese and English.
Note: Please carefully read Charter 8.1 before reading keyboard setup.
3.4.1 Network setup
【3-2 Network management screen of keyboard】
Setup the network parameter of keyboard:
 IP address can‟t conflict with other IP equipment and the default address is
10.10.10.80.
 Subnet mask setup should guarantee Keyboard and Matrix in the same broadcast
region, and the default address is 255.255.254.0.
Network management
IP address:010.010.010.080
Subnet Mask:255.255.254.000
Gateway:010.010.010.246
Start Port:18801
WEB Port:00080
Physical Address:00.50.C2.81.00.A0