User manual

25
1、 Extended function buttons area，functions of 【F1】～【F10】 are speed dome auto
cruising、 pattern tour、auto scan、stop above speed dome motion、track call、auxiliary
switch 5~8 and exit PTZ control. Except for【F4】button, all other extended functions
needs special protocols supports.
Note：Regular operations of camera site control can be performed via 【CALL】/
【PRESET】and joystick lens button on the keyboard.
2、 Current controlled camera，and the mark after it is track call mark, which means that
the keyboard is performing the track call operation to this camera，and the number after
the mark is the track number；as to the track edition, please refer to“other settings” as
follows。Input the camera number or press 【PREV】/【NEXT】button to switch
controlled camera.
3、 There are 8 auxiliary switch status under this camera：Perform control operation via
pressing 【AUX1】~【AUX4】 and extended function auxiliary switch buttons 5~8
（Usually related to four camera site device functions: Light、Rain brush、power、Auto
Scan），● means open，○ means shut. As to work under pressing and keep working
status of the auxiliary switch, please refer to“Other settings” in the following text.
4、 Joy-stick status display area can display joy-stick direction，and X/Y/Z means the
moving amount of the joystick on left, right direction, up down direction and rotation
separately. Moving range on left, right, up and down direction is 0~63，and rotation is
0~7。
5、 Tips display area：operation tips and abnormal status display area.
6、 Display area for other parameters，including current port、control protocol and
operation user.
7、 Keyboard lock status。
5.3 Other Settings
1、 As to communication port、control protocol、baud rate setup, please refer to device
management in the keyboard settings.
2、 Auxiliary switch and track setup：Press 【PROG】 and select setup option，
Auxiliary Switch：Set auxiliary switch control type for PTZ camera control. Working
when pressing：press to close auxiliary switch，and release the button to
shut auxiliary switch；Keep working status：Press the button to close
auxiliary switch，and release the button not to shut auxiliary switch; press
the button again to shut auxiliary switch.
Track Program: 30 track, each with 128 steps of preset positions are supported，and pause time
for each step is from 1 to 240 seconds. In the track program interface, make the program via
【F1】～. 【F10】 buttons, and press 【F9】 to save.