User manual

24
Chapter 5 Camera-site Control
Camera-site Control means using keyboard to control speed dome camera or decoder via
RS-485 or RS-422 directly. After starting，press【MODE】button to switch controlled devices to
PTZ mode.
5.1 User Log-in
【Fig 5-1 Log-in Interface of Camera-site control】
As tot eh setup of communication port、 control protocol、baud rate, please refer to the device
management in keyboard parameter setup: and user code and password, please refer to user
management and password management in keyboard parameters setup. The default factory
settings: User 1 is advanced administer, password is“000000”。 Please change password in due
time.
5.2 Control Operation
【Fig 5-2 Control operation main interface】
Camera-site Devices：PTZ
Communication Port：485
Control Protocol：PelcoP
Baud Rate：9600
User Code：01
Password：