User manual

4.9 Status Table

User can inspect and control the current running status of matrix switcher through keyboard.

There are four status table to show the matrix status.：alarm status table, monitor status table,

camera status table, macro running status table.

 Press ，then to enter alarm status table, which shows all alarming and

alarming camera numbers in the current alarm sub area. User can disarm, end alarming

of single camera or all cameras.

 Press ，then to enter macro running status table, which shows all macros

running in the matrix. Press to stop any running macro.

 Press ，then to enter monitor status table, which shows current status of all

monitors.

 Press ，then to enter camera status table, which shows current status of all

cameras.

4.10 Code Distributor Protocol Setting

【Picture 4-6 Code Distributor Protocol Setting】

Press【PROG】to enter code distributor protocol setting window. Follow the tips and set

protocol and baud rate for the embedded code distributor.

4.11 Switch to other matrixes

Press【SITE】to display matrix lists. There are 8 IP addresses for different matrix switchers.

Choose a matrix by inputting a number or moving joystick, then log in. If the IP address is

invalid, or this matrix is offline, there will be hints saying log-in not allowed.

Note：For the first time the keyboard logs onto the chose matrix, user needs to enter user ID

and password. However, if it is not the first time after the keyboard is powered up, keyboard will

log onto matrix automatically using the same user ID and password that were used in previous

time.

Device Type：code distributor

protocol：PelcoD

baud rate：2400

PROG-set up，ESC-exit