User manual

17
4.5 Alarm Control
1、 【ARM】： Arm and disarm the current camera. When the current camera is in arming
status, the backlight of button will turn red;
2、 【SHIFT】+【ARM】： Arm and disarm all cameras in the alarm sub area where is
keyboard is assigned.
3、 【ACK】： Respond to alarm. When alarm is triggered, the backlight of button will turn
red.
4、 【SHIFT】+【ACK】： Respond to all alarms in the current alarm sub area.
5、 【MUTE】： Press【MUTE】to stop the buzzing of keyboard after alarming.
6、 Relay output：When matrix alarms, keyboard relay automatically opens, normally open
is closed, normally closed is open. Press【MUTE】to shut down relay output.
Alarm Attributes table：Press and then to enter Alarm attributes table. It is a
information table for all alarm sensors, the same as the information in WEB settings. If the
user is a administrator, he can even set alarm link to macro.
Alarm Status Table：Press and then to enter Alarm Status
Table，showing all alarm details and alarming cameras in the current alarm sub area.
4.6 Macro Operations
1、 Monitor default macro：Press 【MON】to focus on monitor, press【MAC】to open or
close the current monitor default macro. The status of monitor default macro is shown
by both the icon after the monitor number and the red LED light of button 【MAC】， the
default macro is open when the LED light is on.
2、 Camera default macro：Press【CAM】to focus on camera，press【CAM】to open or close
the current camera default macro. The status of camera default macro is shown by both
the icon after the camera number and the red LED light of button 【MAC】， the default
macro is open when the LED light is on.
3、 Macro calling：Press【SHIFT】+【MAC】to call or end a macro. Pre-defined macro
buttons are quick access to macro calling, please refer to the following for details.
Note：when ending a macro, camera number and monitor number are required. The
input shall correspond to those when calling the macro, otherwise, the macro will not
end. If user forget the camera number and monitor number, it is suggested that he end
macro in the macro status table.
4、 Macro status table：Press and then to enter macro status table，which
shows all macros that are running in matrix. Press to stop a macro from running.