User manual



Website:www.CCTVSecurityPros.com



DEFAULT SETTINGS: Restore all the settings as the factory setting.
2.2.2.5.6 PTZ SETUP
Move the cursor to【PTZ SETUP 】（Icon highlighted when selected），press【Enter】to
enter into setting interface, you can setup the parameters for each channel separately.
CHANNEL: The channel of PTZ connected.
PROTOCOL: select the protocol of different PTZ, there are two protocols to switch, and the default is
Pelco-D
BAUD RATE: select the different baud rate for your PTZ, there are 1200, 2400, 4800, and 9600
DATA BIT: there are 5,6,7,8 options to select, default setting is 8.
STOP BIT: there are 1and 2 to select, the default setting is 1.
VERIFY: there are None/Odd/Even/Mark/Space to select, the default setting is none.
ADDRESS: Fill the code of respective PTZ
2.2.2.5.7 NETWORK SETUP