User manual
54
11.2 Motion Detection Setup
This Motion Setup tab contains
the settings for camera recording
when motion is detected
[Camera]
Select the camera you wish to setup. The
description below is related to the camera you
selected here.
[Detection Area]
To enable cameras to record automatically by
motion detection, you mush select the detection
areas. To select detection area, place the mouse
cursor over the channel screen and drag the
cursor in any direction you wish. You can assign
up to 5 separate areas for each camera.
[Sensitivity]
Change sensitivity of motion detection. Default
value is set to 15 and it is the recommended value.
[Alarm(M)]
If the box is checked, the internal speaker will beep
when the camera detects motion.
The speaker however will not beep if the camera is
set to Continuous Recording mode in Scheduled
Setup (see page 26). The speaker’s activation time
can set by the scroll lists on the right.
[Control]
When the camera detects motion, the connected
control will activate for the designated time on the
right
[Area Clear]
Delete Detection Area for selected camera. To
manually delete an area, simply drag the
detection area outside the channel screen.
[Area Draw]
Assign entire channel view as detection area.
[Individual camera adjustment]
Adjust brightness, hue and contrast for the selected
camera. Caution: Adjusting these options will affect
recorded data.
[Default]
Click to set brightness, hue and contrast for the
selected camera back to the default values.