User manual


120
1. PPP setup for PSTN/ISDN without router
1. PPP setup for PSTN/ISDN without router
[PPP Setup using KPPPSetup.exe Program]
• To set up PPP connection for PSTN/ISDN, run
KPPPSetup.exe. The program is located in the folder
where the Center Program is installed (usually it is
C:\KSR_Center as shown in the picture above)
[Preparation to Installation]
• The MS Windows Installation CDs are needed.
• A modem is installed in MS Windows.
• If no modem is installed, running KPPPSetup.exe
may give unexpected result. Remember to run it only
after installation a modem.
[Running KPPPSetup.exe]
• KPPPSetup.exe will automatically install PPP
connection for you. Except if you are prompted to
insert the MS Windows Installation CDs, don’t do
anything until the program finishes its work.
• Reboot the Center PC after completing PPP setup by
the program.
• After the system is rebooted, check connection
Center-Site using Center program.
[KPPPSetup.exe will setup the followings:]
• Telephone connection networking
• Telephone connection server
• Telephone caller
• Telephone connection adapter
• TCP/IP protocol
• Telephone connection server setup change
1
2
3
4
[Others]
• In case TCP/IP or telephone connection adapter
was already installed, it will not be installed again.
• You should close “Network Properties” and
“Telephone Connection Server” windows before
running KPPPSetup.exe program.
• Do not execute KPPPSetup.exe program more
than two times at the same time.
• Connect to the site from the center to check the
connection status.
5
[Note]
• Automatic PPP setup for ISDN by using
KPPPSetup.exe is possible only when ISDN
is used through direct connection without
router.
