System information

Manual8

Attention

When the DVR starts up, you are automatically logged on as Administrator in the Windows operating system. This enables

you to access all necessary network and connection protocols to configure the DVR without restrictions.

> DO NOT open the DVR case and add/remove hardware.

> DO NOT add users to the Windows operating system. (The DVR will no longer reboot unattended.)

> DO NOT install any other software on the DVR.

> DO NOT customize the Windows operating system in any way. (Setting screen savers, changing the desktop, adjusting

power settings, etc.)

> DO NOT use the DVR to browse the Internet or read e-mail.

(Computer virus attacks are not covered under warranty.)

Any of these changes will interfere with the

operation of the DVR and will

VOID YOUR WARRANTY!!!

Safety Precautions

When selecting a place for the DVR, avoid locations with:

Excessive heat, such as direct rays of light or heating appliances.

Excessive moisture, dust, or smoke.

Magnetic substances or electric wave equipment in close proximity.

Excessive hot or cold temperature (operating temperature from 5 to 45 degrees C)

Unstable or elevated surface.

Before proceeding further with this manual, make sure to follow the precautions below:

Plug the power cable in after connecting all

devices. Connecting a device when the power is

on may cause problems. Do not forget that the

DVR is automatically booted when the power

cable is plugged in.

Leave enough space around the DVR to avoid tangling cable lines and blocking ventilation.

Keep the DVR clean of dust and foreign objects.

In case of malfunction, do not try to repair the DVR by yourself. Contact your local distributor for assistance.