System information

Manual32

[Motion for Emergency Message]

When selected cameras detect motion, an

emergency message will be displayed

automatically on Monitor window on DN Center

PC, provided Center Software is installed and

running. To specify the IP address of the PC

with Center program installed, eneter the IP

adress on [Emergency IP address].

[Sensor for Emergency]

Select the sensors that will activate the

Emergency Message function. When a sensor is

tripped, the DVR will send a message to the

remote, or “Center” computer.

[Transfer Time (sec)]

Set the time (in seconds) that the modem will

keep the connection to the remote computer

open and active. Any image captured by selected

cameras during that time will also be transmitted.

[Emergency phone numbers]

If you use a modem to connect the DVR to

the remote, or “Center” computer, then

enter the phone numbers of the remote, or

“Center” computer(s) that the DVR will

send the emergency message to. If the

DVR fails to connect to the first number, it

will dial the second number and attempt to

transmit the message.

[Emergency IP Address ]

If the DVR is connected to a LAN (Local

Area Network) or to the Internet through a

DSL or Cable Modem connection, you can

assign the IP (Internet Protocol) address of

the remote, or “Center” computer(s) you

wish to receive the Emergency Message.

[Use E-Mail Service]

You can send an emergency recording data to your e-mail account.

If you click on [Recipient], a window as below appears