Operating instructions

CCT730 V1.1
8
Warning Notes
l All the safety and operating instructions should be read before the CCT730 is operated.
l All the safety and operating instructions should be retained for future reference.
l Ensure all operating instruction and warning notes are complied with at all times.
l Do not use strong or abrasive detergents when cleaning the CCT730.
l There are no user-serviceable parts inside. Please contact a qualified engineer for servicing
and maintenance.
l Do not expose the CCT730 to water or moisture and do not try to operate it in wet areas.
l Please make sure that both ends of the power lead are plugged in.
l Do not drop foreign objects through the CCT730’s case or expose it to moisture.
l Do not attempt to disassemble the CCT730.
l Contact a qualified engineer if the following situation happens:
Ÿ The power lead or plug is damaged.
Ÿ The CCT730 has been exposed to rain or water.
Ÿ The CCT730 does not operate normally by following the operating instructions.
Ÿ The CCT730 falls to the ground or its cover is damaged.
l When replacement parts are required, make sure that the service engineer has used
replacement parts specified by System Q Ltd or that these parts have the same
characteristics as the original ones. Unauthorized substitutions may result in fire, electric
shock, or other hazards.
l Use only with a mounting accessory recommended by System Q Ltd.
l Never push objects of any kind into the case of the CCT730 as they may touch dangerous
voltage points or short cut parts that could result in a fire or electric shock.
l If an outside cable system is connected to the CCT730, be sure that the cable system is
grounded so as to provide some protection against voltage surges and built-in static
charges.
l All normal precautions to avoid component damage due to electrostatic discharge should be
taken during installation and operation.
l To prevent electric shock, do not remove screws or the unit’s cover.