Operating instructions

CCT730 V1.1

3. Quick Installation Guide

The CCT730 is equipped with a hot-swap Hard Disk Drive (HDD) that can be exchanged when

it is full. The following photos illustrate how to install the HDD into its removable caddy.

1) Pull the exterior handle towards you and unlock with the

key provided.

2) Pull the handle outwards until the caddy is free from the

case of the CCT730.

3) Push the release latch to slide the top cover backwards

and remove the HDD.

4) Insert the DC power cable and IDE cable into the HDD.

Make sure the HDD is set to “Master”.

5) Position the empty HDD into the caddy and slide the top

cover back to secure. Secure the HDD using the screws

provided.

6) Slide the caddy back into the CCT730 case and lock it

with the key provided.