User`s manual

2-8 Running state test

When you installed the dome camera and make sure the connecting is correct, you can power it on with

the power supply DC14V (15V) for camera running state test.

Once the power it on, check whether the power indicator led on the PCB board is on. Now the dome

camera should be running self-check – panning, tilting and zooming. After the self-check, the position of the

dome is horizontally on the left limiting position, tilt 30º. This means the PTZ camera is in good condition.

Two abnormal states may follow the self-check:

a. The dome camera makes no action

b. The dome camera is in the state of pan auto-scanning

If the dome camera is in the state of pan auto-scanning, the scanning should be stopped through the

controlling device to avoid possible friction or collision between camera cable and inner housing caused by

inappropriate installation of the camera.

After installing the dome cover, control the dome camera to make slow pan/tilt movement, and observe

its agility and stability, and check whether there is friction or collision between camera, cable and inner

housing.

If the camera movement is unstable and with noise, please check whether the connection between the

speed dome and the bracket is vertical, or whether the camera is in good connection with the peg-board. If not,

switch off the power supply, then check and re-install the unit following the above-mentioned installation

instructions.

If there is friction or collision between the camera, cable and the inner housing, switch off the power and

open the vitreous cover to adjust the position of the camera on the suspender, or tidy up the cables inside the

inner housing. Then reinstall the vitreous cover.

Switch on the power again, control the dome camera to make slow pan/tilt movement, observe its agility

and stability, and check whether there is friction or collision between camera, cable and inner housing.

As per the method introduced above, adjust the unit well.

Part III: Setup and Operate

3-1 Protocol, Baud Rate, Address and Speed setup

It is important to setup the protocol, baud rate and camera address for controlling, Both of the dome

camera and controller must be setting same in the protocol, baud rate and camera address