User`s manual

6
Select the where you want to installing and make sure the place can be sustained its weight. Pencil
the relative positions of the three bores of the bracket on the ceiling, and fix the bracket to the
ceiling with special screws (prepared by the user). Do not forget to push the connecting power,
video and controlling cables through the cable outlet into the bracket tube in advance.
Special Instruction: Pole bracket is used for indoor installation. In some special condition if it is needed to
be used outdoors, in order to prevent the rain water from seeping into the unit and affecting the normal
running, please pay attention to the following points in the installation project:
1. The diameter of the flange on the outdoor vertical pole should be at least 20cm more than that of the
installing flange of the Pole bracket.
2. The cable should not go through the cable-slot on the flange edge of the Pole bracket, it should go
through the central hole of the bracket.
3. The 3 bolts fixing position should be sealed with sealant to prevent the rain water from seeping in.
2-5 Power supply adapter installation
To make sure the power source is at DC15V 2A for the PTZ camera, you’d better to install the AC/DC
power adapter inside the arm bracket or next to the PTZ camera to avoid the drop of voltage, due to there is
a big internal resistor in the DC circuit.
¾ Step 1
Put the power adaptor into the well connected wall bracket and pin the power adaptor with the power
pinning board lest the power adaptor slides out. (See the above figure)
¾ Step 2
Pull the power, video and controlling integrated cable out of the bracket tube via the cable out-going slot,
then fit the dotted-line part of the bracket shown in the figure to the two corresponding pegs on the installed
peg-board, then push the bracket downward until it locks in place. Make sure the bracket fits well with the
bracket installing bottom board, then tighten the Tightening Screw on the bracket. (See the above figure)