User`s manual

14
3.6.1 Setup of Left/right Limiting Positions
The user can freely set one beginning position as Left Limiting Position and one terminal position as
Right Limiting Position. (Remark: If the beginning position and the terminal position is the same position, the
speed dome will scan for 360°). The Left/right limiting positions can be set up with keyboard controller.
1.1 Enter the number “160” (120) and press “PREVIEW” key to function the setup of left/right
limiting positions
1.2 Control the dome camera by joystick, moves it to the right direction and reaches the desired
point as a right limiting position, then enter 131(101), and press “PREVIEW” key, now the
dome’s right limiting position has been set up successfully. Next, move camera to the left
direction and reaches the desired point as a left limiting position, then enter 130(100) and press
“PREVIEW” key again, now the left limiting position have been set up successfully..
1.3 enter 161(121) and press “PREVIEW” key to exit the setup. Now the setup of left/right limiting
positions is completed.
3.6.2 Start scanning between two points
Enter 132(102) and press “PREVIEW” key
3-7 Start 360° scanning function of the Pan/Tilt
The Camera can be 360° endless horizontal scanning. The operation is as below:
a, enter 135 and key “preview for 360 degree endless cruising
b, enter 95 and key “preview for 355 degree back and forth cruising