User`s manual

11
3-3 The particular command and its Definition
The below table is the particular short command for operate the PTZ camera with protocol “Pelco-D” and
“Pelco-P”
These short commands are useful for operation the PTZ function. Please remember
Code No. Definition Code No. Definition
160
begin with left/right limiting position
setup
140
Begin with the tour group setup
161
Finish left/right limiting position setup
141
Finish the tour group setup
130
Set up left limiting position
142
Start Tour Group
131
Set up right limiting position
162
Activate Home Position function
132
Start left/right scanning
163
Disable Home Position function
135
Start 360°scanning of the pan/tilt
164
Set up Home Position
138
Stop auto scanning of the pan/tilt
The below table is the particular short command for operate the PTZ camera with protocol “Pelco-D1”
Code No Definition Code No Definition
120
begin with left/right limiting position
setup
110
Begin with the tour setup
121
Finish left/right limiting position setup
111
Finish the tour setup
100
Set up left limiting position
112
Start Tour
101
Set up right limiting position
122
Activate Home Position function
102
Start left/right scanning
123
Disable Home Position function
105
Start 360°scanning of the pan/tilt
124
Set up Home Position
108
Stop auto scanning of the pan/tilt
For all kinds of operations introduced in the following paragraphs, if PELCO-D1 protocol is chosen for the
control, please choose the Function Codes inside the bracket to operate.
3-4 Set up and Preview Preset Positions
The function of preset positions works in this way: the dome camera saves the current pan/tilt parameters
in number order (1-16), quickly previews those parameters when needed, and adjust the dome to the
corresponding positions. Users can use such devices as controlling keyboard to save and preview preset
positions fast and conveniently. The dome camera can support 16 preset positions.
A. Set up preset positions
After controlling (pan/tilt) the dome camera to the position you want to monitor keyboard, enter the
number for representing the preset position and press the “PRESET” key, then you have set up the preset
position successfully.
Example: Set up preset position No.1
a. Use the joystick to move the dome camera to the desired position.
b. Enter “1”