User`s manual

9
1. Address Setup
As shown in the figure below, DIP-1 to DIP-8 of the 10-button coding switches is used to set up address
of the dome camera from 1 to 63. Control can be realized only when address code of the dome camera is
identical to that of the hard disk video recorder or matrix or controlling keyboard. The coding switches from
DIP-1 to DIP-8 are equivalent to a 8-bit binary figure. The state “ON” of each bit means “1”
while”OFF”means”0”. Table 2 shows states of coding switches
The table of Camera ID: