User Manual

9 / 19
PAL
Connect Power Cable
NTSC
Connect Power Cable
7/ 15
FULL
8 / 16
FULL
4.11 PTZ Function
⑴ Press the MENU (*L) key to enter the system establishment main
menu, choose "system setup"and enter by press the ENTER (**S)
key, "ptz setup" must establish for "yes" ,then press the ENTER
(**S) key to enter the sub-menu . Then adjust the value to
ensure the value match as the channel of ptz connected.
⑵ Press the M4-A (*L) button to enter PTZ controlling function.Press
the M4-B (*L) button again to exit PTZ controllling function.
⑶ Press the M4-B (**S) button to switch channel for PTZ controlling
when the ptz controlling is effective
⑷ The control key definition (as follows):
◄：stop； 8/16 FULL：automatic pattern
►：right； 1/9 FULL：left； (direction)
2/10 FULL：down 3/11 FULL：up；
4/12 FULL： near 5/13 FULL： far (focal distance)
6/14 FULL： big 7/15 FULL： small (aperture)