Owner's manual

24
1.2.4 Setting Day and Night Recording Mode
Day-Night Recording allows you to set up different recording modes for different time frames of the
day. Each day can be divided to 4 time frames, each represented by 1 Span. You can set up a
different frame rate, recording quality, motion sensitivity and noise detection level for each time frame.
1. Click the Day-Night Recording Mode button in Figure 1-12, and this dialog box appears.
Figure 1-13
2. Enable Span1 and specify the Start time in the first time field; select the check box in the second
time field and specify the End time.
3. Use the drop-down list to select Motion Detect or Round-the-Clock to be the recording mode
for the Span 1.
4. Select the check box and click the […] button to adjust recording quality, motion sensitivity and
noise detection level for Span 1.
5. Repeat above steps to set up multiple spans if required.
6. If you want to start monitoring all day on the weekend, select Weekend Apply and select
recording mode to be applied. And define whether your weekend includes Sunday and Saturday
or Sunday only.
7. Click OK to apply the settings.
Note: If the End time field is disabled, the span will run to the start of the next span.