Owner's manual

152
6. Select Support Zoom Function to be able to zoom in and out. Select Normal and the camera will
zoom in once on the moving object. Select Deep Zooming and the camera will zoom in three
times on the moving object.
7. Click the
button to adjust the direction and zoom level of the camera.
8. To set the camera to return to its home position or a preset position when no motion is detected for
a certain time period, specify Idle Mode and Idle Time in seconds. Click on the
button to
preview the designated position. Note that your camera will need to support home position and
preset position.
9. To activate the function at certain times only, click the Schedule button and select Active
Schedule. For details, see Video Analysis Schedule later in this chapter.
10. To outline a mask area where motion will be ignored, draw an area on the camera view and click
Set Mask on the dialog box that pops up. To remove the mask, draw an area bigger than the mask,
and click Remove Mask.
11. Click Test. Move an object through the view of camera and its movement should be tracked. If not,
increase Sensitivity value to increase system sensitivity to motion in the camera view. If you have
set a mask, you can select Enable Mask to display masked area during the test.
12. Click OK to apply the settings.
13. To begin single camera tracking, click the Configure button, select Video Analysis, select Object
Tracking Application, and select Object Tracking Start.
Note: When multiple objects are moving at the same time, the camera will track the object with the
largest area.