Instruction Manual

Viewing Live Video Using WebCam

273

Enabling UpnP in WebCam

1. On the main screen, click the Network button (No. 11, Figure 1-2), select WebCam Server, and

click the Server tab. The Server Setup dialog box (Figure 8-2) appears.

2. Click Detect UPnP. This dialog box appears.

Figure 8-13

3. Click Searching to search the UPnP-enabled routers.

4. If your server is installed with more than one router, select a desired one from the UPnP Router

drop-down list.

5. If you server is installed with more than one network adapter, select a desired one from the IP

Address drop-down list.

6. Click Configure to automatically configure the communication ports on the router.

Tip: If you don’t use the default ports, modify the related ports in the Server Setup dialog box (Figure

8-2) and then click OK. Re-open the dialog box and follow above steps to configure your router.

Note: UPnP technology is also available in other remote applications: Control Center, Center V2,

Remote Playback, Authentication Server, VSM and TwinDVR.