Instruction Manual

Video Analysis

Object Zooming

If only one PTZ camera is available, without the stationary camera, you can simply apply it for the

object zooming function. The feature allows you to configure up to 4 critical views for instant

monitoring and zooming.

PTZ Setup

Before configuring the Object Zooming function, first configure the PTZ device. Refer to the PTZ Setup

of Object Tracking.

Object Zooming Setup

After the above PTZ setup, go back to the menu bar.

1. Click the Configure button (No. 14, Figure 1-2), point to Video Analysis, select Object Tracking

Application, and select Object Tracking Setup to display the Object Tracking Config dialog box.

Then click the Zoom in Object tab in the upper part to display the following dialog box.

Note: No images will show in the right view until you complete the settings below.

Figure 3-8

2. Click for the PTZ setup. Refer to step 1 in the section of Object Tracking Setup.