User's Manual
Table Of Contents
- Welcome
- Important Safety Instructions
- To reduce the risk of fire and shock:
- 1. Keep all slits and openings of the phone unblocked. Do not set the phone on a heating register...
- 2. Do not use while wet or while standing in water.
- 3. Do not use this product near water (for example, near a bath tub, kitchen sink, or swimming po...
- 4. Do not allow anything to rest on the power cord. Place the power cord so that it will not be w...
- 5. Never insert objects of any kind into the product slits, as that may result in fire or shock.
- 6. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aeroso...
- 7. Do not disassemble this product. If service or repair work is required, contact the Motorola a...
- 8. Do not overload wall outlets and extension cords.
- 9. Avoid using during an electrical storm. Use a surge protector to protect the equipment.
- 10. Do not use this cordless phone to report a gas leak, especially if you are in the vicinity of...
- Unplug this cordless phone immediately from an outlet if:
- Installation Guidelines
- 1. Read and understand all instructions and save them for future reference.
- 2. Follow all warnings and instructions marked on theproduct.
- 3. Do not install this product near a bath tub, sink, orshower.
- 4. Operate this phone using only the power source that is indicated on the marking label. If you ...
- 5. Do not place this product on an unstable cart, stand, or table. This product may fall, causing...
- 6. Adjust only those controls that are covered by the operating instructions. Improper adjustment...
- 7. Clean this product with a soft, damp cloth. Do not use chemicals or cleaning agents.
- 8. Use only the power supply that came with this unit. Using other power supplies may damage the...
- 9. Because cordless phones operate on electricity, you should have at least one phone in your hom...
- 10. To avoid interference to nearby appliances, do not place the base of the cordless phone on or...
- To reduce the risk of fire and shock:
- Getting Started
- Setting Up
- Using Your SD7580
19
Using Your SD7580
Making a Call from the Handset or
Base Unit
Press A. When you hear the dial tone, dial the number.
OR
Enter the phone number, then press
A. The phone
number appears on the display before it is dialed. Use the
DELETE to make corrections.
During a call, a timer on the display shows the amount of
time on the call.
SD4580English.book Page 19 Thursday, August 18, 2005 11:19 AM
UNCONTROLLED
DOCUMENT