User's Manual

IB for MD2400/MD2401/MD2420, 21-Apr-2006 Rev. 0
WRITTEN BY: DREAMIS SO PAGE:
11
Of
21
NOTE: When you complete the de-registration process, “HANDSET NEEDS
REGISTRATION” shows in the display. To use the handset, you must register the handset.
Global De-registration
If one or more handsets becomes lost, you should de-register all handsets to ensure proper
system operation. Follow the steps below to de-register both handsets at the same time.
1. Press and hold the page button on the base until the IN USE/CHARGE indicator on the
base flashes.
2. Press and hold the page button on the base again until the IN USE/CHARGE indicator
on the base flashes rapidly.
3. Press and release the page button on the base once. All handsets are de-registered and
HANDSET NEEDS REGISTRATION shows in the display.
Default Setting
As you become familiar with this system, you may prefer to use the system’s original
settings. Follow the steps below to return to the factory default settings.
1. Press the CID/VOL (/\ or V) button to scroll to the DEFAULT SETTING menu.
2. Press the MENU button to enter the menu. DEFAULT SETTING 1YES 2NO shows
in the display.
3. Use the touch-tone pad to select 1YES or 2NO, or use the CID/VOL (/\ or V) button to
move the cursor to 1YES or 2NO. “2NO” is default setting.
NOTE: If you choose YES all the settings in the programmable menu are returned
to factory default setting.
4. Press the MENU button to save your selection. You will hear a confirmation tone.
Telephone Operation
Charge Indicator
When the Voice Mail /Charge indicator is lit, the handset is correctly seated in the cradle and is charging.
Making Calls
1. Pick up the handset, and press the TALK button. Listen for a dial tone.
2. Dial the number you want to call, or dial the number first then press the TALK button.
3. When finished, press the TALK button to hang up.
Answering Calls
1. When the phone rings, pick up the handset, and press the TALK button.
2. When finished, press TALK button to hang up.
NOTE: Adjust the handset volume by pressing the CID/VOL (/\ or V) button during a call.
Call Timer
After you press the TALK button on the handset, the built-in call timer shows on the display and counts the length of time of the call in minutes
and seconds.
Pre-Dialing
1.Make sure the phone is OFF (not in talk mode).
2. Enter the telephone number you want to call. The telephone number shows in the handset display.
3. Press the TALK button on the handset, and the number automatically dials.
NOTE: You may enter up to 32 pre-dial digits.
NOTE: If you want to delete the pre-dial number you entered, press the DEL/MUTE button until all of the digits are erased.
Auto Standby
If you place the handset in the cradle while the handset is off the hook (during a call), the
call is automatically disconnected.
Ringer HI/LOW/OFF
There are two ways to set the ringer to HI/LOW/OFF. One is the traditional way as
described in the MEUN Functions; Handset Setup; Ringer Volume menus. The other
one is this short cut to ringer menu.
1. Make sure the phone is OFF (not in talk mode).
2. Press the #PAUSE button to display 1HI 2LOW 3OFF.
3. Use the touch tone pad on the handset to select 1, 2 or 3, or use the CID/VOL (/\ or V)
button to scroll to your selection. “1HI” is the default setting.
WARNING: It is not recommended that a handset be de-registered unless absolutely
necessary because once a handset is de-registered, that handset’s telephone features
cannot be used until the handset is re-registered.