User's Manual

34
No dial tone
 Check or repeat installation steps:
Make sure the base power cord is connected to a working electrical outlet.
Make sure the telephone line cord is connected to the base and the wall
jack.
 Connect another phone to the same wall jack; if it doesn’t work, the
problem might be your wiring or local service.
 The handset may be out of range of the base. Move closer to the base.
 Make sure the battery is properly charged (12 hours).
 Make sure the battery pack (in the handset) is properly installed.
 The handset should beep when you press the [TALK] button, and the
charge/in use indicator on the base should be lit when the handset rests in
the cradle. If not, the battery may need to be changed.
Handset does not ring
 Make sure the RINGER VOLUME setting is not OFF.
 The handset may be out of range of the base. Move closer to the base.
 You may have too many extension phones on your line. Try unplugging
some phones.
 Check for dial tone.
You experience static, noise or fading in and out.
 The handset may be out of range of the base. Move closer to the base
 Relocate the base. Make sure the base is not plugged into an outlet with
another household appliance.
 Charge the battery.
Unit beeps
 Clean charging contacts on handset and base with a soft cloth or an
eraser.
 See solutions for “No dial tone”.
 Charge battery for 12 hours or replace the battery.
Memory dialing doesn’t work
 Did you program the memory location key(s) correctly?
 Did you follow proper dialing sequence?
C
ALLER
ID S
OLUTIONS
No Display
 Charge the battery (for 12 hours). Or replace the battery.
 Make sure that the unit is connected to a non-switched electrical outlet.
Disconnect the power converter from the outlet and plug it in again.