User's Manual

3 Speed Dialer Section 3
IN USE
Indicator
(OFF)
(––
– /FLASH)
Memory
Station
Numbers
(AUTO/PROGRAM)
(PAUSE/REDIAL)
2 Making/Answering Calls
Section 2
2-A Making Calls
2-B Answering Calls
≥For best operating performance, see
section 5-B.
(CH)
RINGER Selector
IN USE
Indicator
(OFF)
(PAUSE/REDIAL)
(LOUD)
(––
– /FLASH)
1
Press .
≥The IN USE indicator lights.
≥If an alarm tone sounds, see section 5-F.
2
Dial a phone number.
3
To hang up,
press
(OFF) or place the handset on
the base unit.
≥The indicator light goes out.
(–– – /FLASH)
Lift the handset off the base unit and
press .
≥You can also answer a call by pressing any
button except
(OFF) (Any Key Talk).
(–– – /FLASH)
Selecting the ringer volume
Set the RINGER selector to ON or OFF.
≥When set to OFF, the unit will not ring.
To redial the last number dialed
Press ¤ (PAUSE/REDIAL).
To adjust the receiver volume
4 levels (HIGH, MEDIUM, NORMAL, LOW) are
available.
Press
(LOUD) while talking.
≥Each time you press
(LOUD), the volume level will
change.
If noise interferes with the
conversation
Press (CH) to select a clearer channel or move
closer to the base unit.
(–– – /FLASH)
You can store up to 10 phone numbers in the handset. The
dialing buttons (
(0) to (9)) function as memory stations. The
IN USE indicator light must be off before programming.
1
Press (AUTO/PROGRAM).
≥The IN USE indicator flashes.
2
Press a memory station number ((0) to (9)).
3
Enter a phone number up to 16 digits.
≥When you store the last number dialed, press
(PAUSE/REDIAL) instead of entering a phone number.
4
Press (AUTO/PROGRAM).
≥A beep sounds.
≥To store other numbers, repeat steps 1 through 4.
If you misdial
Press (OFF) to end storing. ¤ Start again from
step 1.
To erase a stored number
Press (AUTO/PROGRAM) ¤ the memory station
number (
(0) to (9)) for the phone number to be
erased ¤
(AUTO/PROGRAM)
.
≥A beep sounds.
Press ¤ (AUTO/PROGRAM) ¤
¤ the memory station number (
(0) to (
9)
).
(–– – /FLASH)
3-A Storing Phone Numbers in
Memory
3-B Dialing a Stored Number
≥If a pause is required for dialing, press
(PAUSE/REDIAL) where needed. Pressing
(PAUSE/REDIAL) counts as one digit (4-D).
≥If additional dialing is necessary after using speed
dialing functions such as AUTO (3-B) or REDIAL,
wait until speed dialing is finished to continue
further dialing. Otherwise, the unit may not dial
properly.
Lighted handset keypad
(KX-TC1467LAB only)
The handset dialing buttons will light
when you press a button, lift the handset
off the base unit, or when a call is
received. The lights will stay on for a
while after pressing a button, lifting the
handset or answering a call.