User's Manual
Getting Started Section 1
1
1-A Accessories 1-B Location of Controls
1-C Settings
∑ AC Adaptor . . . . . . . . . . . . . . . . one
∑ Telephone Line Cord . . . . . . . . . one
∑ Battery . . . . . . . . . . . . . . . . . . . . one
∑ Handset Cover. . . . . . . . . . . . . . one
3
Charge the battery for 15 hours.
≥See section 5-A for more details.
≥The IN USE/CHARGE
indicator lights and a beep
sounds.
Handset Base unit
≥Use only with Panasonic AC adaptor PQWATC1461M.
≥The AC adaptor must remain connected at all times. (It is normal for the
adaptor to feel warm during use.)
≥To connect a standard telephone on the same line, see section 5-E.
≥When more than one unit is used, the units may interfere with each other.
To prevent or reduce interference, please keep ample space between the
base units.
OR
IN USE/CHARGE Indicator
To select the dialing mode TONE (preset) or PULSE
You can program the dialing mode using the handset near the base
unit. The IN USE indicator light must be off before programming.
(#) (PULSE)
Press
(AUTO/PROGRAM) ¤ ($) ¤ OR ¤ (AUTO/PROGRAM).
($) (TONE)
≥To cancel during programming, press
(OFF). Start again from the
beginning.
STOP
1
Connect as shown.
To Power Outlet
(AC 120 V, 60 Hz)
Telephone Line
Cord
To Single-Line
Telephone Jack
Raise the
antenna.
AC Adaptor
Fasten the AC
adaptor cord to
prevent it from
being
disconnected.
Hook
Charge Contacts
(5-A)
IN USE/CHARGE Indicator
(1-C, 4-E)
(HANDSET\LOCATOR) (4-E)
Antenna
(1-C, 5-B)
Hook (5-C)
C
O
R
D
L
E
SS
z
900
M
H
IN USE Indicator
(2-A, 5-A)
Antenna
(PAUSE/REDIAL)
(2-A, 4-D)
Charge Contacts
(5-A)
(––
–
/FLASH)
(2-A, 4-A)
(AUTO/PROGRAM)
(1-C, 3-A)
(LOUD) (2-A)
(OFF) (1-C, 2-A)
RINGER Selector
(2-B)
($) (TONE) (4-C)
(CH) (Channel) (2-A)
2
Install the battery in the
handset and close the
handset cover, locking it
into place.
Red
Lead
Black
Lead