Specifications

T: Trigger Output Delay Setting Command
Name Trigger output delay setting command
Header code
T
Function It sets the delay time of external output timing signal for strobe light.
@ 99 T 99999 R/W FF CR LF
Command
Header Channel
Output
delay time
Write
flag
Checks
um
Delimiter
Response
@ 99 O FF CR LF
OK
command
Header Channel Checksum Delimiter
@ 99 N 9 FF CR LF
NG
command
Header Channel Error No.
Checks
um
Delimiter
The output delay time may be set from 0µs to 10,000µs.
Although it can be set increment of 1µs as setting, it will actually be rounded in approximately 20µs
increments at 300µs or lower and 100µs increments at 320µs or higher.
D: Strobe Light Delay Setting Command
Name Strobe light delay setting command
Header code
D
Function It sets the delay time for strobe light.
@ 99 D 99999 R/W FF CR LF
Command
Header Channel
Strobe light
delay time
Write
flag
Check
sum
Delimiter
Response
@ 99 O FF CR LF
OK
command
Header Channel Checksum Delimiter
@ 99 N 9 FF CR LF
NG
command
Header Channel Error No.
Checks
um
Delimiter
Strobe light delay time may be set from 0µs to 10,000µs.
Although it can be set increment of 1µs as setting, it will actually be rounded as shown at the
“2-5 Light Delay Time”.
(The delay time can not be set with 1µs step)