Specifications

4. Connectors
4-1 Output connector: SM connector (mfd. by JST)
Pin No. 12 V output 24 V output Output with fan
(Note)
1 OUT+(+12V) OUT+(+24V) OUT+(+24V)
2 OUT- NC OUT+(+12V)
3 OUT- OUT-
4 Fan GND
Connector SMP-02V-BC SMP-03V-BC SMP-04V-BC
Note) With fan: L1/L2 (FAN) output connector for lighting with a fan
Output with fan is not available when strobe (ON) is selected with mode selector DIP switch # 1.
4-2 External interface connector: (15-pin D-sub plug with M2.6mm Screws)
Use a shielded cable no longer than 3m for the control line.
Pin No. Color of the Optional Cable
(Note)
Signal
1 Black Light intensity date B1[LSB]
2 White Light intensity date B2
3 Red Light intensity date B3
4 Green Light intensity date B4
5 Yellow Light intensity date B5
6 Brown Light intensity date B6
7 Blue Light intensity date B7
8 Purple Light intensity date [MSB]
9 Gray External control (INIT/EXT) B9
10 Pink Light intensity data write (/WR) B10
11 White/Black ON/OFF control (ON/OFF)
12 Red/Black Trigger input (/TRIG) B12
13 Green/Black Trigger delay output (TDLY) B13
14 Yellow/Black Pulse output (FLSH) B14
15 Brown/Black Signal GND
Note) Optional cable for external control: EXCB2-B3 (3m long cable with one end cut.)
4-3 RS-232C Connector 9-pin D-sub plug with inch screws
Use a shielded crossover cable no longer than 3 m for the control line.
Pin No. Signal
1 NC
2 RXD
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 NC