User's Manual

Transmitter
When the Transmitter is switched on it automatically
starts to search for free a band.
Once it is located it locks to it during this search.
The LED will initially blink and then
change to a constant light once it has
completed this procedure and secured a band.
Attention:
When there are many 2.4GHz wave devices
around, the search time may be longer.
Receiver
When the receiver is switched on, it will also look for the transmitter which has the same ID. When it
finds the same ID, the LED will flash and when the band is fixed, the LED changes to a constant
light. ( Just like the Transmitter )
Attention:
When there are other 2.4GHz wave devices around, the scanning time may take longer.
If the receiver cannot locate the transmitter's signal or suffers from interference, the steering servo
will not function.
When the fail-safe function is off, the signal to the throttle channel is cut off.
This means that the speed controller throttle function or alternatively the throttle servo will not operat
e
Both functions will revert to normal operation when the receiver obtains the correct signal.
If the receiver cannot obtain the signal from the transmitter after one second, the receiver will
automatically scan the bands to find the transmitter signal.
ID registration and setting of fail safe function
SAFE SET UP PROCEDURE
POWER
SWITCH
LED
4