User's Manual

7
Condition
Ref.pag
Reason
There is interference
page４
page４
p a g e 3
page 4
page 1
page 1
p a g e 4
Gbuggy.indd 7 2011/05/13 11:13:11
Trouble shooting
How to settle it
The car cannot
drive
The car is
out of control
Controller power
lamp is dark
The batteries are put
in wrong polarity
Install the batteries in
correct polarity.
Batteries are exhaust, Change the all batteries
to new one.
Safety function is working
as the car is heating up
by driving rough road or continuously driving.
Hold to drive more than
15 minutes and cool down
the car.
Batteires are exhaused.
Change the all batteries
to new one.
Same frequency radio
controlled is operated at near
Change the place or operate
later.
Controller batteries are
exhaused.
Change the all batteries
to new one
This device complies with Part 15 of the FCC Rules. Operations is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which correct the
interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit difference from that to which the receiver is needed.
* Consult the dealer or an experienced radio/TV technician for help.