User's Manual

www.xmodsRC.com 9
Setting Up Your Controller
Installing the Battery
Your controller needs a 9V battery. We recommend
9V alkaline batteries for best performance.
1) Make sure the power switch is in the OFF
position.
2) Place your finger in the battery compartment
cover and slide (in the direction shown) until
the cover unlatches.
3) Place one 9V battery in the compartment, matching
the polarity symbols (+ and –) marked inside.
4) Replace the cover and snap it shut.
Note: You cannot shut the cover if the battery has been
inserted incorrectly.
Battery Notes
• When you notice the LED dims or the range of your car decreases, replace the battery.
• Dispose of old batteries promptly and properly. Do not burn or bury batteries.
• Use only fresh batteries of the required size and recommended type.
• Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or
rechargeable batteries of different capacities.
• If you do not plan to use the vehicle for several days, remove the batteries. Batteries can leak
chemicals that can destroy electronic parts.
60-47X_XMODS Street_En.120408.in9 9 12/09/2008 10:37:13