User's Manual

Marker being pumped – hammer and bolt traveling to the rear – ball ready to drop in breach.
The ball is temporarily held in place by the ball detent installed in your T2 marker
(It is hidden under to top tube and protrudes into the breach. When the hammer
clears the sear, the sear will catch (with a click).
Sear Engaged, Bolt moving forward ball entering the chamber.
At this point, move the pump forward (away from the rear of the marker). This
will move the bolt forward, which will push the ball past the detent and into the
barrel of the marker.
Sear Engaged, Bolt at rest, ball in chamber.
This is one full cycle of the T2.
Note: This marker comes with an ‘auto-trigger’. The auto-trigger allows
the user to hold down the trigger and pump the marker – firing the marker