User's Manual

The good news and a great innovation by CCM is that the Valve Seal is
replaceable without scrapping the whole Valve Pin Assembly. An N70-
011 O-ring is used to repair a leak. Simply take apart the valve body from
the valve top hat (or base) carefully (it is held together with blue Loc-tite)
and snap on the O-Ring. Screw the pieces back together, using Loc-tite
again, and you are ready for the field.
18. Clean these parts completely and reassemble.
NOTE: When reassembling the Valve Assembly – stack the Valve Spring,
Valve, and Valve body, and Valve Retaining Nut on top of the
Autococker® Valve Tool and slide the body over this assembly. Be sure
not to cross thread the Valve Retaining Nut into the Chassis of the marker
upon reassembly. Take your time, go slow, and get help from a qualified
airsmith if you do not know what you are doing.