User's Manual

2. Loosen the Frame Screws (2 1/8
th
Allen Screws are submerged in the frame)
that attach the frame to the marker chassis. The screws are of two different
lengths – ensure you replace these properly when reassembling (shorter
screw in back).
3. Now that the frame screws are loosened you can slide the AT arm off the AT
lug (attached to the pump arm with Loc-tite). This will take some practice –
but I find that depressing the pump arm near the lug while finessing the frame
and AT arm does the trick.
4. Once the AT arm is disconnected , depress the trigger while sliding the frame
toward the rear of the marker and remove the frame from the body.
5. Remove the Auto Trigger Arm and Cam Retention Pin from the .45 frame.