User's Manual

Turn the Allen key clockwise to lower the lug (allow the marker to fire with a
longer trigger pull – or during auto trigger – later in the cycle) and to the
anticlockwise to raise the lug (allow the marker to fire with a shorter trigger pull -
or during auto trigger - earlier in the cycle).
Lug adjustment shown in cutaway. Lug is at its highest point.
If the lug becomes to easy to turn with the Allen key it may vibrate loose and
cause your timing to change. There is an Nylon Set Screw in the base of the
hammer (inside the same the main spring goes into) that can be tightened. Take
the Sear Lug completely out of the hammer and tighten the nylon set screw
(10/32 Allen Key) until you see the nylon screw intrude into the area where the
Sear Lug goes. Stop there and reinstall your Sear Lug. This will cause the Sear
Lug to drag on the Nylon Screw and cause it to not vibrate loose while playing.